Fill the brake reservoir with the brake fluid and bleed the brake system. Connect 2 brake tubes and the brake fluid level sensor connector.ģ. The 2013 Hyundai Sonata comes in 5 configurations costing 20,895 to 27,595. If there is a big jump in engine speed, there is no lock-up. 0-L 4 Cyl turbo) Works only intermittently. When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly.
#2009 hyundai sonata clutch master cylinder fluid image install
Install the master cylinder on the brake booster with 2 nuts.Ģ. Lock-up operation, however, is prohibited when A/T fluid temperature is too low. Be careful not to bend or damage the brake lines when removing the master cylinder.ġ. Remove the master cylinder(C) from the brake booster (D). Remove the master cylinder mounting nuts (B) and washers.Ħ. To prevent spills, cover the hose joints with rags or shop towels.ĥ. Disconnect the brake lines (A) from the master cylinder. Remove the brake fluid from the master cylinder reservoir (C) with a syringe.Ĥ. Disconnect the brake fluid level switch connector (A), and remove the reservoir cap (B).ģ. Remove air cleaner mounting bolts (B) from the air cleaner mounting bracket and air cleaner body (A).Ģ. Vehicle Brakes and Traction Control Hydraulic System Brake Master Cylinder Service and Repair Removal and Replacement Repair Proceduresĭo not spill brake fluid on the vehicle it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.ġ. The attached pics below correlate with the directions. Here are directions specific to your vehicle. Here is a video that shows how that is done: The new brake master cylinder will need bench bled before install. That way, you'll never have to pay for it again.įirst, here is a link that shows how in general one is replaced.
When you get the replacement part, make sure it has a lifetime warranty. Replacing the brake master cylinder isn't too hard of a job.
0 kommentar(er)
